Table of Contents
Advertisement
Bin Thermistor
To remove the bin thermistor:
Remove two 1/4-in. hex-head screws from the
bottom of the cutter grid cover and pull the cover
from the ice machine.
Cutter Grid Cover
Disconnect the thermistor plug from the bottom of
the control panel.
Remove the hex-head screw and clamp securing
the thermistor to the side wall and remove
thermistor.
The bin thermistor should read 12.49 KΩ at room
temperature.
°F
°C
0
-18
10
-12
32
0
50
10
70
21
90
32
Thermistor Plug
Thermistor Resistance
81,715 - 99,874 Ω
59,422 - 72,627 Ω
30,266 - 36,992 Ω
18,219 - 22,267 Ω
10,280 - 12,564 Ω
6,387 - 7,807 Ω
Cutter Grid
To remove the cutter grid:
1.
Remove two 1/4-in. hex-head screws from the
bottom of the cutter grid cover and pull the
cover from the ice machine.
2.
Disconnect the cutter grid and bin thermistor
connectors from the bottom of the control
housing.
3.
Remove the 2 hex-head screws from both sides
of the cutter grid, (Note that the longer screw
and white spacer are on the right side.)
Disconnect
Note: Take care not to scratch the icemaker liner.
4.
Slide the cutter grid forward and out of the unit
and place it on a protected work surface.
5.
Remove the spacer from the right cutter grid
bracket tab.
– 19 –
Cutter Grid Cover
Disconnect
Spacer
(Continued next page)
Hide quick links:
Advertisement
Table of Contents
