Evaporator Thermistor; Water Distributor - GE Monogram ZDIS150WSS Technical Service Manual

6. Unsnap the 2 ice guides, if necessary, from
the cutter grid tabs. (There should be a slight
outward tilt after the guides are installed.)
Ice Guide
7. Bend the metal tabs outward, if necessary.

Water Distributor

1. Remove the cutter grid from the unit. See (
.)
Grid
2. Pull out on the left and right water distributor
retainers, and remove the tabs from the slots in
the evaporator.
3. Pull the distributor forward and remove the
water hose.
Water Hose
Ice Guide
Cutter
– 20 –

Evaporator Thermistor

To remove the evaporator thermistor:
1. Remove the cutter grid. (See
2. Disconnect the evaporator thermistor from the
bottom of the control housing.
3. Remove the 2 hex-head screws from the water
trough and pull the trough from the unit.
4. Reach behind the accumulator, and unclip the
evaporator thermistor.
5. When installing, snap the thermistor onto the
evaporator tubing behind the accumulator.
.)
Cutter Grid
Disconnect