Electronic Control Housing Components - GE Monogram ZDIS150WSS Technical Service Manual

Electronic Control Housing Components

Note: The control housing components consist of:
• Electronic control board
• Dual transformer
• Light switch
• Push-button switch assembly
1. Remove the cutter grid cover and the cutter
grid. (See
Cutter Grid
2. Disconnect the 2 thermistor connectors. (See
and
Thermistor Evaporator Thermistor.
3. Remove the 4 hex-head screws from the control
housing and lower the housing to access the
components.
To Remove the Electronic Control Board
1. Disconnect the 6 harness connectors from the
board terminals.
2. Remove the 2 mounting screws and remove the
electronic control board.
.)
)
To Remove the Dual Transformer
1. Disconnect the 6-pin wire connector from the
harness.
2. Remove the 2 mounting screws from the
transformer bracket.
3. Disconnect the green ground wire from its
terminal.
Bin
To Remove the Light Switch/Push-Button
Assembly
Note: If the switch assembly or light switch is
replaced, the replacement part and decorative
overlay must be ordered using the model number of
the icemaker. The service replacement switch is not
supplied with a decorative overlay
1. Peel off the decorative overlay from the front of
the control housing.
– 21 –
Transformer
2nd screw on opposite side
(Continued next page)