Digital Screen; Depth - Minelab E-Trac Instruction Manual

Digital Screen

24
E-Trac has the Digital Screen that shows both
the ferrous content (FE; range 1–35) and the
conductivity (CO; range 1–50) of a target.
The enlarged FE and CO numbers are the
coordinates of the Target Crosshair displayed
in the Smartfind Discrimination Pattern.
There is a thumbnail of the active
Discrimination Pattern above the
FE-CO numbers.
Discrimination Pattern
Thumbnail
A small image of the
current Discrimination
Pattern.
Before Detection
To switch between Smartfind and Pattern
displays, press the Detect button. The
conductivity and ferrous information of
the target will clear as you switch between
Pattern and Digital, until a new
detection is made.
Note: When using the Digital Screen, the
Discrimination Pattern is still active.
After Detection
Ferrous-Conductivity
Numbers
The area where enlarged
FE-CO numbers of an
accepted target are
displayed.

Depth

The Depth Gauge, visible in the Pattern,
Digital and QuickMask Screens, indicates the
approximate depth of a detected target. The
top of the indicator represents the position
of the coil and the bottom represents
approximately 30cm (12") from the coil.
Before Detection
Once a target is detected, a crosshair will
appear in the Depth Gauge indicating the
approximate depth of the target.
After Detection
The Depth Gauge is also updated for
rejected targets.
25