Minelab E-Trac Instruction Manual page 7

assembly
8
Attaching the Lower Shaft to the
Upper Shaft:
1 Release the Upper Shaft camlock by pulling
the lever away from the shaft.
2 Feed the coil cable up through the inside
of the Upper Shaft, ensuring the camlock
side of the shaft is facing the ground.
3 Slide the Upper Shaft over the Lower Shaft,
so the coil cable appears out the top.
Connecting the Shaft Assembly to the
Handle Assembly:
1 Release the Control Box camlock by pulling
the lever away from the Control Box.
2 Align and push the coil cable connector
into the socket underneath the Control Box,
firmly tightening the retaining ring
to secure.
3 Push the Handle Assembly onto the Upper
Shaft, as far as it will go.
4 Lock the Control Box camlock by pushing
the lever flat onto the Control Box.
Attaching the Armrest Strap:
1 Clip both buckles onto the outer sides of
the armrest.
Attaching the Headphones:
1 Plug the headphone jack into the
headphone socket, located in the
rubber seal at the battery end of the
Handle Assembly.
The headphones may be plugged or
unplugged at any time.
Disconnecting the coil:
1 Reverse the steps in 'Connecting the
Shaft Assembly to the Handle Assembly' ,
'Attaching the Lower Shaft to the Upper
Shaft' and 'Attaching the coil to the
Lower Shaft' .
2 Pull the coil cable out from inside the
lower shaft.
WARNING: Do not attempt to
completely remove the shaft assembly
while the coil cable is still connected to
the Control Box.
9