Introducing The Control Panel - Minelab E-Trac Instruction Manual

Introducing the Control Panel

16
Power
Pressing turns E-Trac On/Off.
Holding for three seconds resets the detector (p. 19)
to the Factory Preset settings, prior to startup.
Left Shift
Pressing in the Edit Screen changes the
Edit Frame Size (pp. 44–5).
Pressing in Combine inverses the selected
Discrimination Pattern (pp. 51–3).
Navigation Buttons
Used for adjusting settings in Detect Screens.
Also used in navigating the Menu. (Clockwise from
left: Left, Up, Right, Down.)
Menu
Used to access the Main Menu at any stage of
detector operation. This allows access to various
settings (pp. 34–7).
Pinpoint
Pressing turns Pinpoint On/Off . Pinpoint (p. 33)
assists in locating the exact position of a target prior
to recovery.
Backlight
Press to turn the Backlight On/Off. The Backlight
provides greater screen clarity in dim conditions. The
Backlight glows during the startup sequence. Turning
Off will extend battery life.
Right Shift
Pressing in the Edit Screen changes the
Edit Mode (pp. 44–5).
Pressing in Combine inverses the selected
Discrimination Pattern (pp. 51–3).
QuickMask
Press to access QuickMask, switching between
QuickMask (p. 32) and Detect screens (p. 22).
Noise Cancel
Starts the scan for the quietest operating frequency.
The scan takes 30 seconds (p. 31).
Accept/Reject
Pressing in the Detection Screens accepts or rejects
the detected target.
Pressing in the Menu takes you back one level.
Detect
Pressing, while in the Pattern Screen, will switch the
Detection Screen to Digital Screen, and vice versa if in
Digital. Pressing while in the Main Menu, QuickMask or
Edit Screen, returns to the Pattern/Digital Screen (pp.
23–4) at any stage of operation.
17