Digital Display - Minelab Explorer SE Quick Start Manual

30

Digital Display

Ferrous Content
The Explorer SE has an alternative
Digital display that shows both
the ferrous content (FER) and the
conductivity (COND) of a target with
numbers from 0 to 31.
The FER and COND numbers are the
coordinates of the Target Crosshair
displayed in Smartfind.
A FER value of 0 represents low-ferrous
content and a value of 31 represents
high ferrous content. Similarly, a COND
value of 0 represents low conductivity
and 31 represents high conductivity.
Size/Conductivity
It is important to note that when using
Digital, discrimination settings (either
the current Discrimination Pattern
or the Iron Mask) are still active and
targets outside the accepted area will
not produce a signal or indicate FER and
COND numbers on the display.
31 Ferrous Content
The conductivity and ferrous
information of the target will clear as
you switch between Smartfind and
Digital, until a new detection is made.
The last used display will appear the
next time you turn on the detector. Any
adjustments to Discrimination Patterns
that are made in Smartfind will be
retained and used in Digital.
While detecting a target, try switching
from Smartfind to Digital, to compare
the results. In time, you may prefer to use
different displays for different conditions.
31
0
To switch between Smartfind and
Digital displays:
Press DETECT .