Safety And Warnings - Fisher & Paykel HC60DCXB1 Installation Instructions And User Manual

Electrical Shock Hazard
All electrical work must be done in accordance with local and/or national
electrical codes as applicable. For safety, this product must be earthed. If
you are unfamiliar with methods of installing electrical wiring, employ the
services of a qualified electrician. Turn off power at service entrance before
installing wiring or servicing this product.
Weight Hazard
The wall canopy is heavy. Please ensure adequate care is taken when
installing the wall canopy to prevent personal injury. The wall canopy must
13.1 kg
be installed onto a solid wall, stud, beam or truss. Weight of the product is
(HC60)
13.1 kg (HC60) / 14.8 kg (HC90) / 19 kg (HC120).
14.8 kg
(HC90)
19 kg
(HC120)
Important safety precautions
Please read the entire set of instructions before installing the wall canopy.
■ ■
Ducting accessories are not supplied. All ducting must comply with local requirements and
■ ■
building codes.
Before connecting any pipes, consult municipal ordinances to ensure that any applicable
■ ■
regulations concerning the discharge of exhaust air are adhered to and request permission from
the person in charge of the building.
Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from
■ ■
appliances burning gas or other fuels.
There must be adequate ventilation of the room when the wall canopy is used at the same time
■ ■
as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high a
concentration of gas in the air).
When the canopy is turned on at the same time as other appliances powered by energy other
■ ■
than electricity, the air outlet must not be greater than 4 Pa (4x10-5 bar).
The minimum distance between the cooktop surface and the filters of the wall canopy shall be
■ ■
600 mm, or 650 mm if installed over a gas cooktop.
Stainless steel is very easily damaged during installation if abraded or knocked by tools. It
■ ■
is recommended to protect the top of the canopy with cardboard or polystyrene during the
installation to minimise the risk of damage occurring.
To comply with electrical safety regulations, this canopy must be plugged into a socket near the
■ ■
appliance. The socket must be accessible, or have an accessible isolating switch, to enable the end
user to isolate the canopy from the power for the purpose of internal cleaning or maintenance.

Safety and warnings

WARNING!
WARNING!
1