Dispenser Assembly - GE Profile PSF26PGWBB Technical Service Manual

Dispenser Assembly

The dispenser assembly consists of the interface,
display board, dispenser shield, and duct door
functioning parts. The dispenser interface can
be removed to access the display board and the
dispenser shield mounting screws. The interface is
held in place by 4 tabs that hold it to the dispenser
recess. To remove the interface, it is necessary to
grasp the bottom lip of the interface on either side
and gently pull it towards you. There are 3 wire
harnesses connected to the display board.
TAB
LIP
HARNESSES
TAB
Note: The interface and display board are replaced
as a complete assembly.
When assembling, insert top tabs into the top of
dispenser recess fi rst, then snap the bottom into
place.
The dispenser shield can be removed to access
the cradle switch, duct door, duct door solenoid,
and dispenser LED lights. The dispenser shield is
attached to the dispenser recess with 4 Phillips-
head screws.
Note: The dispenser LED lights cannot be replaced
individually. The dispenser shield and LED lights are
replaced as an assembly. Check model number for
correct assembly.
TAB
LIP
TAB
– 46 –
Dispenser Shield
Bottom View of Dispenser Shield
LED
LED
Dispenser Shield Removed
LED
LED