GE Profile PSF26PGWBB Technical Service Manual page 45

6. Remove the support from under the evaporator
tubing.
7. Remove the 3 Phillips-head screws that hold
the CustomCool™ unit to the bottom of the
refrigerator compartment.
Support
8. Move the unit to the right, then carefully pull the
left side towards the front of the refrigerator.
9. Place the unit vertically on its right side.
10. Peel back the foam seal from the left side and
the tape from the rear of the unit.
Tape
Foam Seal
11. Release the 3 tabs and remove the cover.
CustomCool™ Components
Damper Assembly
Light Bulb
(under shield)
Fan
– 45 –
Heater
Thermistor