General Operation Description; Weighing A Product; Taring A Container - Tor-Rey LSQ Series User Manual

WEIGHING A PRODUCT

At the end of the countdown sequence, zeros will appear in the display, at this moment the scale is ready to use.
(Otherwise, see the section reference to zero), then you place on the plate the product to weigh and you will see the
weight in the indicator.

TARING A CONTAINER

When you wish to weigh a product in a container but you do not want to consider the containers weight during
the operation, you may use the tare function
You can use the manually tare or also you can recording until 20 tares in memory and make reference each
PLU to one programmed tare, in this form the weight of the product will be substracted to the weight of the recorded
tare. (see page 13 of the programming manual)
For use the manually tare follow the next procedure:
Place the empty container over the plate of the scale, and wait until the weight is stabilized
Press the
zeros in the indicator and the TARE indicator on display.
Note the TARE legend still lit from the
To erase this function you will press again the
Notice this function is substractive, is substracted of the maximum capacity, for example: for a scale of 40lb, if you tare a
weight of 5lb, the scale only can weigh to 35 lb.
. For use programming tares, only you need to reference the desired tare in the corresponding PLU. (see page 13 of the
programming manual).

GENERAL OPERATION DESCRIPTION

key. This will make that the weight of the container will consider as a part of the plate, appearing
key was oppressed even if you places weight to the scale.
key, once you remove the container from the plate.
10