Blower Control Box Snap Disc Operations; Blower Operating Instructions - Quadra-Fire 31I-ACC Owner's Manual

R
M. Operating the Blower Control
Box with Snap Disc
1. The blower will turn on/off automatically
when set to AUTO. Figure 15.1.
2. When set to MANUAL, the fan will turn on/
off only when you turn it on or off. This
setting over-rides the internal snap disc.
. Adjust the speed of the fan by turning the
HIGH/LOW knob to the desired setting.
N. Blower Operating Instructions
1. Initial (cold) startup:
the Burn Rate Air Control all the way up until it stops and
push the Start-up Air Control back until it stops.
tends to cool the appliance. Leave the blower off until the
burn is well established, i.e., 0 minutes.
2. High Burn Setting: Both controls are open. Burn Rate
Air Control is pulled up and the Start-up Air Control is fully
pushed in. Blower may remain on.
. Medium High Burn Setting*: Burn Rate Air Control is
closed then opened to 1 inch (pull up )to fully open. Blower
may remain on.
4. Medium Low Burn Setting*: Burn Rate Air Control is
closed then opened to 1/4 inch to 1/2 inch. Leave the blower
off until the burn is well established, i.e., 0 minutes.
5. Low Burn Setting*: Burn Rate Air Control is closed. Leave
the blower off until the burn is well established, i.e., 0 min-
utes.
*NOTE: For burn settings  to 5 the Start-up Air Control
needs to be pushed in (Open) then pulled forward to acti-
vate the Automatic Combustion Control (ACC).
For maximum efficiency and lowest emissions,
NOTE:
when operating the blower in either the automatic or manual
setting for the low and medium low burn settings leave the
blower off until the burn is well established, i.e., 0 minutes.
6. The blower is equipped with a rheostat (speed control). The
highest blower speed is obtained by turning the rheostat on,
then adjusting back towards "OFF" as far as possible with-
out turning the blower off. For a low blower speed, turn the
control knob clockwise as far as possible
February 10, 2010
Figure 15.1
Open both controls fully by raising
The blower
NOTICE!
Do NOT operate a circulating fan within close prox-
imity, approximately 4 ft (1.2m), of appliance
• Can reverse air flow, blowing hot air into appli-
ance cavity.
• Can damage appliance blower due to overheat-
ing.
7044-140B
3100-I ACC Wood Insert
MANUAL: Over-rides the
internal Snap Disc
AUTO: Fan will turn
ON/OFF automatically
and is controlled by the
internal Snap Disc
Page 15