Table of Contents
Advertisement
72
User Manual of Network Speed Dome
Figure 6-43 Tampering Alarm
2. Check Enable Video Tampering checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 1 Set the Motion Detection Area in Section
6.6.1 Configuring Motion Detection.
4. Click
to edit the arming schedule for tampering. The arming
schedule configuration is the same as the setting of the arming schedule for motion
detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in Section
6.6.1 Configuring Motion Detection.
5. Check the checkbox to select the linkage method taken for the tampering. Notify
surveillance center, send email and trigger alarm output are selectable. Please refer
to Step 3 Set the Alarm Actions for Motion Detection in Section 6.6.1 Configuring
Motion Detection.
6. Click
to save the settings.
6.6.3 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the speed domes.
Steps:
© Hikvision
Advertisement
Table of Contents
