Table of Contents
Advertisement
User Manual of Network Speed Dome
speed dome information via SNMP port. By setting the Trap Address, the speed dome
can send the alarm event and exception messages to the surveillance center.
The SNMP version you select should be the same as that of the SNMP software.
Steps:
1. Enter the SNMP Settings interface:
Configuration > Advanced Configuration > Network > SNMP
2. Check the corresponding version checkbox (
,
3. Configure the SNMP settings.
The configuration of the SNMP software should be the same as the settings you
configure here.
4. Click
© Hikvision
Figure 6-15 SNMP Settings
) to enable the feature.
to save and finish the settings.
48
,
Advertisement
Table of Contents
