Checking The Navigation Status; Checking Sensor Learning Status And Driving Status; Checking The Connections Of Leads And Installation Positions; To Clear Values - Pioneer AVIC-D3 Operation Manual

Checking the connections of
leads and installation positions
Check that leads are connected between
the and the vehicle. Please
also check whether they are connected in the
correct positions.
(5) Speed
Speed detected by the navigation is
indicated. (This indication may be different
from the actual of you r so
do not use th is instead of the speedom-
eter of your
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of of the street is indicated.
• •••••••••••••••••••••••
To clear val ues...
If you want to delete the learned resu Its stored in
"Distance", "Speed Pulse" or "Learning Sta-
tus", touch the relevant resu It, then touch
"Clear".
D The navigation can automatically use
its sensor memory based on the outer dimen-
sions of the tires.
(4) Degree of learning
situations for distance (Dis-
tance), turn (Right Turn), left turn (Left
Turn) and 3D detection (3D Detection) are
indicated by the of bars.
D When tires have been or chains fit-
turning on the Pulse allows the
to detect the fact that the tire diameter
has and automatically replaces the
value for calcu distance.
D If the ND-PG1 is
the distance cal-
culation value cannot be replaced automati-
(4) • • • • • • • • • • • • • • • • • • • • • • • •
(1)
(2)
(3)
(6) (7) (5)
(1) Distance
Driving distance is indicated.
(2) Speed Pulse
Total number of pulses is indicated.
(3) Learning Status
Current driving mode is indicated.
D If you touch "Peak Hold Reset", the maxi-
mum and minimum I values
indicated in "Acceleration" and "Side
Acceleration" are reset.
D You cannot the atthe
center.
D
Demo Mode in the
menu enables you to perform a demon-
stration with random values.
Adjust Look:
Touch "Adjust Look" to d
the
2
Touch "3D Calibration"
The 3D Calibration screen appears.
1
Touch "Settings" in the NAVI MENU,
then touch "Hardware Info".
the drivi ng sta-
status
learn status of the 3D sensor and cable con-
nection status, can be checked.
Checking sensor learning status
and driving status
Checking the Navigation Status
-
~
z
68