Before Installing This Product; To Prevent Damage; Connecting The System - Pioneer AVIC-D3 Operation Manual

Connecting the System
,Before installing this product
• This product is for vehicles with a 12-volt battery and negative grounding. Check the
battery voltage of your vehicle before installation.
• To avoid shorts in the electrical sys-
tem, be sure to disconnect the (-)
battery cable before beginning
installation.
To prevent damage
I
A
WARNING
I
When replacing the fuse, be sure to only use a fuse of the rating prescribed on this
product.
• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
• This product cannot be installed in a vehicle that does not have an ACC (accessory)
position on the ignition switch.
ACC position No ACC position
• When the
"ANT CTRL"
mode is set to
"Tuner",
the vehicle's antenna can be stowed or
turned off by following the instructions below.
- Change the source from radio (AM or FM) to another source
Turn the source off
- Turn off the ignition switch (ACC OFF)
• If the"
ANT CTRL"
mode is set to
"Power",
the vehicle's antenna can be stowed or
turned off only when the ignition switch is turned off (ACC OFF).
• To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especial-
ly important to insulate all unused speaker leads, which if left uncovered may cause a
short circuit.
• Attach the connectors of the same color to the corresponding colored port, i.e., blue con-
nector to the blue port, black to black, etc.
• Refer to the owner's manual for details on connecting the power amp and other units,
then make connections accordingly.
• Since a unique BPTL circuit is employed, do not directly ground the
8
side of the
speaker lead or connect the
8
sides of the speaker leads together. Be sure to connect the
8
side of the speaker lead to the
8
side of the speaker lead on this navigation system.
• If the RCA pin jack on this product will not be used, do not remove the caps attached to
the end of the connector.
-