Resetting The Microprocessor; Reset The Navigation System Without Changing The Condition Memory; Reset The Navigation System To The Initial (Factory) Setting; About The Data Being Deleted - Pioneer AVIC-D3 Operation Manual

the combination of the
About the data being deleted
The information is erased by pressing the RESET
button or the yellow lead from the
(or removi ng the battery
the following items are not erased:
• status and status
• Memory areas that were memorized manually
• Areas to avoid
•
Locations in "Address Book"
in "Emergency Info"
Reset the navigation system to
the initial (factory) setting
When you want to erase memorized setti ngs and
retu rn the to its initial (factory)
settings, carry out the following
1
Turn the engine ON or set the ignition
switch to ACC position.
2
Press the RESET button with a pen tip or
other pointed instrument.
o
Some settings and data are not
erased.
additional products
system.
y-nny-nf"'I"")C'C',"")Y-
must be reset under the fol-
• Pressing the RESET button deletes the
contents of the system's memory.
Reset the navigation system
without changing the condition
memory
ng the RESET button of the navigation
lets you reset the to its
initial
C'ryt-r,nrH'
without changing the condition
memory.
The
lowing conditions:
• to this product for the first time
installation.
• If the to
nnny-elTn ny-nnnY-l\/
• If there appear to be problems with the opera-
tion of the
• When
ment.
• When
that connect to the
Resetting the Microprocessor
I
A
CAUTION
I
1
Turn the ignition switch OFF.
2
Press the RESET button with a pen tip or
other pointed instrument.
RESET
button
o
If you have connected other equipment (for
example, a TV to this navigation system,
be sure to that too.
20