Table of Contents
Advertisement
The screen of the remote control starts functioning after inserting the batteries. UFO logo
and flashing clock indicator starts appearing on the screen.
Make sure that the heater is plugged in and "H" is seen on display screen which
indicates the heater is functioning. "H0" indicates that the heater is in stand by position.
H1, H2, H3, H4 and H5 indicates the increasing power level from low to high. Heater
consumes 2300 W power at "H5" level while radiating a maximum amount of heat.
Heater operates at H1 level, when the On/Off button is pressed on the remote control. If
the heater was turned off while operating at a power level, it will continue operating at
the same power level next time the power turned on.
Power Mode Adjustment
+
-
Press
/
buttons to adjust the power mode of your heater. Time settings are to be
conducted for the rest of the functions to operate.
Time Settings
Adjusting the time
Press Clock button.
+
-
Press
/
buttons to set hour and minutes. Press Clock button to save your settings.
Press Cancel button to cancel time settings.
NOTE! Repeated presses on the buttons will gear the speed of buttons and intervals with
the presses will slow down the process.
ON/OFF Timer Adjustment
Set the correct time before using the On/Off Timer function and make sure
WARNING!
the heater is on while adjusting the timer.
IMPORTANT WARNING! Heater will still be operating at a low power level until the
preset "On Time" when the On/Off Timer is set. Thus, it prevents you from possible
dangers such as covering the heater or wrong positioning by warning you with the
visible glowing of the heating element. Also; indicators on the remote control and the
display screen on the heater body, will warn you visually. Always check these
indicators for your safety.
25
Advertisement
Table of Contents
