Table of Contents
Advertisement
First time installation
Channel search
The Channel search procedure can be performed in different
ways.
Automatic search
• Press ok to start searching for channels.
Manual search
The information you need to enter in this menu is available in
magazines covering satellite TV reception or on the Internet.
Transponder frequency: Specify the frequency in MHz with the
numeric buttons. If you enter the wrong value, erase with the
button.
Polarisation: Select Horizontal, Vertical, Circular left or Circular
right.
Symbol rate: Specify the symbol rate with the numeric buttons.
If you enter the wrong value, erase with the
Network search: Select Yes if you want to search on all trans-
ponders connected to a specific network.
• Press ok to start searching for channels.
Advanced channel search
The information that must be entered in this menu is available in
satellite TV magazines or on the Internet.
You can use this menu if you are looking for some "special" chan-
nels (i.e. non-DVB standard channels) which can only be found
when you have entered the necessary settings here.
Transponder frequency: Specify the frequency in MHz.
Polarisation: Select Horizontal, Vertical, Circular left or right.
Symbol rate: Enter symbol rate with the numeric buttons.
PID Video: Enter the PID (Packet Identifier) for the video signal.
PID Audio: Enter the PID for the audio signal.
PID PCR: Enter the PID for the PCR (Programme Clock Refer-
ence).
Press opt if you want to preview the channel.
• Press ok to tune in channels using the given parameters.
All channels that are located using the advanced manual search
will automatically be given a generated name, for example,
P0001 for the first channel, P0002 for the second, etc.
• Press ok to save the new channel or back if you don´t want
to save it.
GB 20
☛
button.
Advertisement
Table of Contents
