Snmp - Digisol DG-BG4100N User Manual

3.6.5 SNMP

Choose Advance > SNMP, and the page shown in the following figure appears. You can
configure the SNMP parameters.
The following table describes the parameters of this page:
Field
Enable SNMP
System Description
System Contact
System Name
System Location
Trap IP Address
Community Name
(Read-only)
Community Name
(Read-Write)
Select it to enable SNMP function. You need to enable
SNMP, and then you can configure the parameters of this
page.
System description of the DSL device.
Contact person and/or contact information for the DSL
device.
An administratively assigned name for the DSL device.
The physical location of the DSL device.
Enter the trap IP address. The trap information is sent to the
corresponding host.
The network administrators must use this password to read
the information of this router.
The network administrators must use this password to
configure the information of the router.
108
DG-BG4100N User Manual
Description