Lower Control Panel Assembly Removal/Installation - Sony BETACAM SX DNW-A30 Maintenance Manual

Installation
7. Install the cassette compartment while inserting
slantingly in the direction as shown in the figure.
m
. Insert it slowly while sliding the cassette compart-
ment slightly back and forth so that the gear on the
right of the cassette compartment does not touch the
chassis.
. Never move the cassette compartment to right and
left. If unnecessary force is applied to right and left,
the gear or parts may come off.
8. Insert the four legs of the cassette compartment for
fixing the position into the four holes on the mechani-
cal deck for fixing the position by pressing the po-
rtions C as shown in the figure.
Cassette lid
Leg for fixing
the position
Hole for fixing
the position
Flexible card wire
9. Connect the harness to the connector (CN930) on the
CL-29 board.
10. Install the cassette compartment bracket assembly.
11. Install the plate MD assembly and the upper lid.
DNW-A30/A30P
DNW-30/30P
C
Cassette compartment
CN930
C
Harness
2-5. Cassette Compartment Removal/Installation

2-6. Lower Control Panel Assembly Removal/Installation

2-6. Lower Control Panel Assembly
Removal/Installation
n
Turn off the power and unplug the power cord before
starting the removal/installation.
Removal
1. Take both side handles on a lower control panel and pull
them slightly forward, then pull them more strongly. Then
the lower control panel tilts upward (to 90 degrees position).
2. Disconnect the flat cable from the connector (CN145)
on the back of the lower control panel.
3. Loosen two screws in bottom corners of the lower control
panel assembly. (Loosen the screws until screw's top are
exposed from the lack of the panel assembly.)
4. Push the loosened screws the direction indicated by the
arrow, and raise the lower control panel assembly.
B3 x 12
Lower control panel assembly
Flat cable
Installation
5. Set the notches of the panel assembly to the claws of
the arms and insert the lower control until making a
click sound.
6. Fix the lower control panel assembly with two screws.
Claws
B3 x 12
Notches
Lower control panel
assembly
7. Connect the flat cable to the connector (CN145).
8. Return the lower control panel to 0 degree, then store.
CN145
B3 x 12
Claws
B3 x 12
Notches
2-7