Interface Module Leds; Nsq1Gt8C40/Nsq1Gt8P40 - HP A-F5000 Installation Manual

LED
(yellow)
(red)
NOTE:
Do not remove the CF card when the CF LED is flashing. Otherwise, the file system on the CF card will be
damaged.

Interface module LEDs

NSQ1GT8C40/NSQ1GT8P40

Figure 55 NSQ1GT8C40/NSQ1GT8P40 LEDs (NSQ1GT8P40 as an example)
Table 28 Interface module LED description
LED
(yellow/green)
(green)
Status
Off
MPU status LED
On
Off
On
Alarm LED
Fast
flashing
(8 Hz)
Status
Off
Solid green
Copper port LED
Flashing green
Solid yellow
Flashing yellow
Off
Solid green
SFP port LED
Flashing green
Description
The MPU is in standby state or is not powered on.
The MPU is in active state.
NOTE:
The firewall supports one MPU, so the MPU can only be in
active state.
The system is operating properly and there is no alarm.
A fault has occurred to the system or the available power is
insufficient. In this state, check the system log immediately.
A critical fault has occurred to the system. In this state,
handle the fault immediately.
Description
No link is present.
A 1000 Mbps link is present.
Data is being sent or received at 1000 Mbps.
A 10/100 Mbps link is present.
Data is being sent or received at 10/100 Mbps.
No link is present.
A link is present.
Data is being received or transmitted at 1000
Mbps.
71