Completing The Configuration Wizard - HP A-F5000 Installation Manual

Table 10 NAT configuration items
Item
Interface
Dynamic NAT
Source IP/Wildcard
Destination
IP/Wildcard
Protocol Type
Internal Server
External IP: Port
Internal IP: Port

Completing the configuration wizard

Click Next on the NAT configuration page to enter the page shown in
Description
Select an interface on which the NAT configuration will be applied. Generally, it is
the outgoing interface of the device.
Specify whether to enable dynamic NAT on the interface.
If dynamic NAT is enabled, the IP address of the interface will be used as the IP
address of a matched packet after the translation.
By default, dynamic NAT is disabled.
If dynamic NAT is enabled, set the source IP address and wildcard for packets.
If dynamic NAT is enabled, set the destination IP address and wildcard for packets.
If dynamic NAT is enabled, select the protocol type carried over the IP protocol,
including TCP, UDP, and IP (indicating all protocols carried by the IP protocol).
Specify whether to enable the internal server.
You can configure an internal server on the NAT device by mapping a public IP
address and port number to the private IP address and port number of the internal
server.
By default, the internal server is disabled.
IMPORTANT:
Configuration of the internal server may result in disconnection with the device (for
example, specify an external IP address as the IP address of the local host or as the IP
address of the current access interface). Perform the operation with caution.
When the internal server is enabled, set the valid IP address and service port number
for the external access.
If the internal server is enabled, set the IP address and service port number for the
server on the internal LAN.
41
Figure 44.