Installing A Fan Tray - HP A-F5000 Installation Manual

Figure 20 Insert an interface module
Fasten the captive screws on the interface module with a Phillips screwdriver.
3.
After the firewall is powered on, the RUN LED flashes once and then flashes fast (at 8 Hz). It flashes
4.
slowly (at 1 Hz) after the application is loaded. This means that the interface module runs properly.
For more information of the interface module LEDs, see the chapter
NOTE:
If there is a great resistance when you push an interface module into a slot, first remove the filler panels
•
above and below the slot, then install the interface module. Install the removed filler panels to prevent
dust from entering the chassis.
If slots 1 through 4 of the A-F5000 are all installed with interface modules, the interface modules are
•
powered on in the sequence of slot 1, slot 2, slot 3, and slot 4, with RUN LEDs lighting up in turn.

Installing a fan tray

Follow these steps to install a fan tray:
Gently push the fan tray slowly along the slide rails into the slot until it touches the slot bottom.
1.
21
"Appendix B LEDs."