Esc Pass Codes; Notes On Specific Telnet/Terminal Clients; Windowstm Client Programs - AMX NetLinx Integrated Controller NI-4000 Instruction Manual

ESC Pass Codes

There are 'escape' codes in the pass mode. These codes can switch the display mode or exit pass
mode. The following 'escape' codes are defined.
Escape Pass Codes
Command
+ + ESC ESC
+ + ESC A
+ + ESC D
+ + ESC H

Notes on Specific Telnet/Terminal Clients

Telnet and terminal clients will have different behaviors in some situations. This section states
some of the known anomalies.
Windows
Anomalies occur when using a Windows client if you are not typing standard ASCII characters (i.e.
using the keypad and the ALT key to enter decimal codes). Most programs will allow you to enter
specific decimal codes by holding ALT and using keypad numbers.
For example, hold ALT, hit the keypad 1, then hit keypad 0, then release ALT. The standard line
feed code is entered (decimal 10). Windows will perform an ANSI to OEM conversion on some
codes entered this way because of the way Windows handles languages and code pages.
The following codes are known to be altered, but others may be affected depending on the
computer's setup.
Characters 15, 21, 22, and any characters above 127.
This affects both Windows Telnet and Terminal programs.
NetLinx Integrated Controllers
Description
Exit Pass Mode:
Typing a plus (shift =) followed by another plus followed by an ESC (the escape
key) followed by another escape exits the pass mode. The Telnet session
returns to "normal".
ASCII Display Mode:
Typing a plus (shift =) followed by another plus followed by an ESC (the escape
key) followed by an 'A' sets the display to ASCII mode. Any ASCII characters
received by the device will be displayed by their ASCII symbol. Any non-ASCII
characters will be displayed with a \ followed by two hex characters to indicate
the characters hex value.
Decimal Display Mode:
Typing a plus (shift =) followed by another plus followed by an ESC (the escape
key) followed by a 'D' sets the display to decimal mode. Any characters
received by the device will be displayed with a \ followed by numeric characters
to indicate the characters decimal value.
Hex Display Mode:
Typing a plus (shift =) followed by another plus followed by an ESC (the escape
key) followed by an 'H' sets the display to hexadecimal mode. Any characters
received by the device will be displayed with a \ followed by two hex characters
to indicate the characters hex value.
TM
client programs
Programming
113