Nibe F1245 User Manual page 27

temperature
Menu
1.1
If the house has several climate systems, this is indicated on the display by a
thermometer for each system.
If the heat pump has an accessory for cooling or integrated cooling function
this is shown in the display with an extra tab.
Set the temperature (with room sensors installed and activated):
Setting range: 5 - 30 °C
Default value: 20
The value in the display appears as a temperature in °C if the heating system
is controlled by a room sensor.
To change the room temperature, use the control knob to set the desired
temperature in the display. Confirm the new setting by pressing the OK but-
ton. The new temperature is shown on the right-hand side of the symbol in
the display.
Setting the temperature (without room sensors activated):
Setting range: -10 to +10
Default value: 0
The display shows the set values for heating (curve offset). To increase or re-
duce the indoor temperature, increase or reduce the value on the display.
Use the control knob to set a new value. Confirm the new setting by pressing
the OK button.
Chapter 3 | F1245 – at your service NIBE™ F1245 25