Advertisement
Step 6
(This step 6 should be done only when the initial installation of HDFX-
100-TR or HDFX-10R-TR is done or attached display is changed.)
i) Disconnect the HDMI cable from the Transmitter
ii) Disconnect the AC/DC adapter in Transmitter and connect it
again to trigger EDID emulation.
Then, the Transmitter start to read EDID from display and write in it
while HDCP LED in Transmitter flash around 10 sec. (This could be
repeated up to twice.)
HDCP LED in Transmitter will blink at every 0.5 sec. (It means EDID
emulation is done.)
iii) Connect Transmitter to HDMI sources over HDMI cable again.
Then, HDCP LED will be turned off.
1-5 Installation (continued)
Troubleshooting
The display displays only black screen.
Check that all AC and DC plugs and jacks used by external power
supplies (both Opticis and others) are firmly connected.
Ensure that power bars are live.
Ensure that the Tx and Rx boxes plug correctly to the media receiver
or computer and display, respectively.
Check if the media receiver or computer and display are powered on
and properly booted.
Re-boot up the system after reconnecting the optical system cable.
Screen is distorted or displays noises.
Check if the graphic resolution is properly set. Go to the display
properties and tap the settings. Ensure that the resolution sets less
than 1080p (1920x1080) at 60Hz refresh ratio.
Reset the system.
Power down, disconnect and reconnect the optical system cable or
DC power adaptors, and power up.
Maintenance
No special maintenance is required for the optical system cables and power
supplies. Ensure that the cables and power modules are stored or used in a
benign environment free from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis or its authorized distributor.
1-6 Troubleshooting, Maintenance, Technical Support
Advertisement
