Makita 3601B Instruction Manual page 6

Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release it.
CAUTION :
Before plugging in the tool, always check
to see that the trigger switch actuates pro-
perly and returns to the "OFF" position
when released.
Operation
o s e t
the tool base on the workpiece to be cut without the bit making any contact. Then
turn the tool on and wait until the bit attains full speed. Move the tool forward over
the workpiece surface, keeping the tool base flush and advancing smoothly until the
cutting
i s
complete.
When doing edge cutting, the workpiece surface should be on the left side of the bit in
the feed direction. (See the figure below)
Feed direction
/
/
' / / / B i t revolving direction
(View from the top of the tool)
/ /
/ / / / / / / , / / I / ,
/ /
Correct bit feed direction
NOTE :
0
Moving the tool forward too fast may cause a poor quality of cut, or damage to the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit size, the kind of workpiece.and depth of cut. Before
beginning the cut on the actual workpiece,
it
i s advisable to make a sample cut on a
piece of scrap lumber. This will show exactly how the cut will look as well as enable you
to check dimensions.
*When using the straight guide or the trimmer guide, be sure to install it on the right side
in the feed direction. This will help to keep it flush with the side of the workpiece.
6