Makita 3601B Instruction Manual page 10

MA1 NTENANCE
CAUTION :
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
a t
the
same time. Use only identical carbon
brushes.
Use a screwdriver to remove the rear cover.
Use a screwdriver t o remove the brush
holder caps. Take out the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
Then install the rear cover with the screws.
I
LLimit
mark
CAUTION:
Do not turn the tool on without the rear cover installed in place.
To maintain product SAFETY and RELlABl LITY, repairs, any other maintenanace or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.