Fitting The Plinth; Fitting The Plinth (Kitchener And Toledo Only); Fitting The Splashback (Optional); Customer Care - Rangemaster Toledo 110 Ceramic User Manual

Fig.7-16
ArtNo.000-0012 - Securing the plinth
Fig.7-17
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig.7-18
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
������������������������
������������
Fig.7-19
����������
��������������
Check the appliance is electrically safe when you have finished.
������������
���������������
INSTALLATION

Fitting the Plinth

Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig.7-16).
Please complete your contact details in the front of this
section. Please inform the user how to operate the cooker
and hand over the instruction pack.
Fitting the Plinth
Fit the inner plinth to the bottom front of the cooker using
the 5 screws provided (Fig.7-17).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig.7-18).
Fitting the Splashback
The splashback secures to the back of the hotplate using the
securing clips and screws provided. Slide the clips into the
openings on the rear of the hotplate, making sure to align the
holes in the clips to the holes in the hotplate (Fig.7-19).
Position the splashback on the rear of the hotplate and secure
with the screws supplied.

Customer Care

Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand oven the
instructions.
Thank you.
28
(Kitchener and Toledo only)
(optional)