Final Fitting; Fitting The Plinth - Rangemaster Elise User's Manual & Installation Instructions

12. Final Fitting

Fitting the Handrail
Using the 2 mm Allen key supplied, loosen the two retaining
screws in the base and side of the handrail support. Fit the
handrail support onto the locating bosses on the fascia (Fig.
12-1).
Note: The handle support should face upwards.
Push the support back against the fascia and tighten the
one retaining screws. Repeat for the other side. Check that
each support is secure.
Locate the handrail onto the support tabs and, using the
3 mm Allen key supplied, tighten the one retaining screws in
the bottom to secure (Fig. 12-2).

Fitting the Plinth

Remove the three screws for the plinth mounts along the
front bottom edge of the cooker (Fig. 12-3). Fasten the plinth
using these screws.
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Turn on the oven. Check the oven fans start to turn and that
the oven heats up.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Check the appliance is electrically safe when you have finished.
INSTALLATION
Retaining screw
Retaining
screw
ArtNo.350-0017 - Securing the plinth
29
Fig. 12-1
Retaining screw
Fig. 12-2
Fig. 12-3