Table of Contents
Advertisement
6
HOOD SAFETY SWITCH WIRE CONNECTIONS
1. Locate the BLACK and GRAY/RED wires from the remote start harness.
2. Using the (2) supplied IDC wire taps (in hood safety switch parts bag), connect the wires listed
below together and crimp the IDC wire taps in place using pliers. Ensure that a complete and
secure connection is made.
HOOD SAFETY SWITCH WIRE
Dark GRAY
Dark GRAY
NOTE: Switch is not polarity sensitive.
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
7
GROUND CONNECTION
1. Locate the 10 mm factory bolt, mounted high up under the dash, near the vehicle dashwall,
supporting the factory "Unit - Light Auto Off" module. (FIGURE V)
2. Using a 10 mm ratchet, remove the 10 mm bolt.
3. Using the 10 mm bolt just removed, secure the remote start harness BLACK/ORANGE ground
wire with ringlet and tighten with a 10 mm ratchet.
NOTE: USING A 3/8" DRIVE TORQUE WRENCH, MAKE SURE THAT THE 10 mm GROUND
BOLT IS SECURELY TIGHTENED TO 78-121 INCH/POUNDS.
Steering
Column
FIGURE V
REMOTE START HARNESS WIRE
GRAY/RED
BLACK
10 mm
Factory Bolt
9
4280159 Rev. A 10/10
Hide quick links:
Advertisement
Table of Contents
