Dome Light Connection; Door Lock Connection - Mazda 0000-8F-N02B Installation Instructions Manual

12
WIRE HARNESS CONNECTIONS - DRIVER'S KICK PANEL, continued

DOME LIGHT CONNECTION

1. Locate the 6-pin WHITE connector at the Body Control Module
mounted in the left kick panel area. (FIGURE PP)
2. Using a razor knife carefully cut back 1"-2" of the electrical tape
to expose the wiring. (
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE
PP & QQ for proper connector and pin location.
VEHICLE'S DOME LIGHT WIRE
YELLOW/RED
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.

DOOR LOCK CONNECTION

1. Locate the 30-pin WHITE connector at the Body Control Module
mounted in the left kick panel area. (FIGURE RR)
2. Using a razor knife carefully cut back 1"-2" of the electrical tape
to expose the wiring. (
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE RR
& SS for proper connector and pin location.
3AZ
3AB 3AY
3AC
3AB 3AA 3X
FIGURE SS
VEHICLE'S DOOR LOCK WIRE
VIOLET/WHITE
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
! CAUTION: BE EXTREMELY CARE-
4E
VIEW FROM HARNESS SIDE
FIGURE QQ
! CAUTION: BE EXTREMELY CARE-
3Z 3V 3S 3P 3J
* * *
V/W
3U 3R 3O 3L
3W 3T 3Q 3N 3K 3H
VIEW FROM HARNESS SIDE
4A
Y/R
REMOTE START HARNESS WIRE
3G
3D 3A
3I 3F 3C
3E 3B
REMOTE START HARNESS WIRE
15
6-pin
FIGURE PP
YELLOW/RED
30-pin
FIGURE RR
VIOLET/WHITE
4280159 Rev. A 10/10