0
ELECTRICAL SYSTEM GENERAL PROCEDURES; continued
Wire Tie Procedure
1.Wrap wire tie around
the harnesses you
wish to secure
together.
Tapered End
Wire Tie Head
1
VEHICLE PREPARATION
1. Disconnect and Remove Battery
a. Disconnect and isolate the negative and positive battery
terminals. (FIGURE A)
b. Remove battery hold-down bracket assembly by loosen-
ing both 10 mm nuts and pivoting lower retainers toward
vehicle dashwall. (FIGURE A)
c. Carefully remove the battery from vehicle.
2. Remove the following components:
a. Using a fiber stick, remove the driver's side scuff plate.
The scuff plate is held by 3 clips. (FIGURE B)
2.Insert the Tapered
End of the wire tie
into the Wire Tie
Head.
3
3.Pull the Tapered End
through the Wire Tie Head
until the wire tie is snug.
FIGURE A
FIGURE B
4.Trim wire tie end
after tightening.
10 mm
Socket
4280159 Rev. A 10/10