Hornet 700T Installation Manual page 16

H1/10 BROWN (+) siren output
Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at
the same point you connect the control module's black ground wire.
H1/11 RED (+)12V constant power input
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse
in the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE (-) 200 mA auxiliary channel/delayed accessory output
If programmed for an auxiliary output, this wire will provide a (-) pulse when the lock button on the factory
transmitter is pressed twice within three seconds. This output can be used to control optional accessories. If pro-
grammed for delayed accessory output, this wire will provide (-) ground when the ignition is turned off and will
continue to output (-) ground until a door is opened then closed. This can be used to energize the accessory
circuit in the vehicle to keep the radio and other accessories on after the ignition is turned off. For delayed
accessory output, Feature 7 must be programmed to the one-chirp setting. (See System Features Menu section.)
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply (-) 200 mA, and connecting directly to a solenoid, motor, or
other high-current device will cause the module to fail.
16
© 2001 Directed Electronics, Inc. Vista, CA