Panoramic Sliding Roof; Operational Faults - Skoda Yeti Owner's Manual

42 Locking and Unlocking

Operational faults

Automatically operated power windows do not operate
If the battery of the car has been disconnected and then reconnected, the auto-
matically operated power windows do not operate. The system must be activated.
Proceed as follows in order to re-establish the function:
● switch on the ignition,
● slightly pull on the upper edge of the relevant button and hold it until the win-
dow is closed,
● release the switch,
● you must pull the respective switch again in upward direction for approx. 3
seconds.
Operation in winter
Ice accumulating on the surface of the windows during the winter may result in a
greater resistance when closing the windows and the window may stop and move
back several centimetres
It is necessary to put the force limiter out of operation in order to close the win-
dow ⇒ p age 41, Force limiter of the power windows.
WARNING
The system is fitted with a force limiter ⇒ p age 41. If there is an obstacle, the
closing process is stopped and the window goes down by several centimetres.
You should then take particular care when closing the windows! You may oth-
erwise suffer severe injuries as a result of getting an arm, for example, jam-
med in the window!
CAUTION
● Keep the window glass clean to ensure correct function of the electric win-
dows.
● In the event of a freezing up of the windscreen, first of all eliminate the ice
⇒ p age 182 and then operate the power windows otherwise the power window
mechanism could be damaged.

Panoramic sliding roof

Introduction
The panoramic sliding roof with sun screen can only be operated with the control
dial when the ignition is switched on
tions.
After switching off the ignition, it is still possible to open, close and tilt the panor-
amic sliding roof or the sun screen for approx. 10 minutes. However, it is no longer
possible to operate the panoramic sliding roof and the sun screen the moment
you open one of the front doors.
Opening and tilting the panoramic sliding roof
Comfort position
– Turn the switch to position
Open partially
– Turn the switch to a position in area
Open fully
– Turn the switch to position

position).
Tilting and closing
– In order to tilt, press the switch on the recess in the direction of the roof.
In order to close, press down the switch on the recess and then push it for-
–
wards.
⇒ f ig.
21. The control dial has several posi-
Fig. 21 Control dial for the panoramic
sliding roof
⇒ f ig.
C 21.
D .
B and hold it in this position (spring-tensioned

£