Power Panoramic Sliding/Sliding Tilting Roof; Operational Faults In The Automatic Power Windows - Skoda Octavia Owner's Manual

The convenience opening of the windows by means of the key in the driver's/
front passenger's lock is only possible within 45 seconds of deactivating or acti-
vating the alarm system.
Setting options
Information on the setting » operating instructions for Infotainment, chapter Set-
ting vehicle systems (CAR button).

Operational faults in the automatic power windows


First read and observe the introductory information and safety warn-
ings on page 38.
The automatic power windows do not work if the vehicle battery was disconnec-
ted and connected while a window is open. The system must be activated.
Proceed as follows in order to re-establish the function:
›
Switch on the ignition.
›
Pull the top edge of the button and close the window.
›
Release the button.
›
Pull the relevant button upwards again for approx. 3 seconds, and keep it press-
ed down.
In the winter, ice accumulating on the surface of the window may cause there to
be more resistance when closing the window. The window will stop and move
back several centimetres.
It is necessary to deactivate the force limiter to close the window

Power panoramic sliding/sliding tilting roof

Introductory information
The power panoramic sliding/tilting roof (abbreviated in the following as 'sliding/
tilting roof'), can only be when the ignition is turned on and when the outdoor
temperature is higher than -20 °C.
The sliding/tilting roof can still be operated for approx. 10 minutes after switching
the ignition off. However, as soon as the driver or front passenger's door is
opened it is no longer possible to operate the sliding/tilting roof.
CAUTION
Always close the sliding/tilting roof before disconnecting the battery.
■
If the battery has been disconnected and reconnected, it is possible that the
■
sliding/tilting roof does not operate correctly. Next, move the rotary switch into
position » Fig. 24
A

and forwards tightly. The sliding/tilting roof opens and closes again after around
10 seconds. Do not release the control dial until it has done so.
Using the system
Comfort position
›
Turn the switch to position
When the sliding/tilting roof is in the comfort position, the intensity of the wind
» page 40. noise is reduced.

Open partially
›
Turn the switch to a position in area
Open fully
›
Turn the switch to position
sition).
Tilting roof
›
Turn the switch to position
›
Press the switch in the region of the lug
Closing
›
Turn the switch to position
›
Press the switch on the recess
on page 41, pull it, and hold onto the recess downwards
Fig. 24
Control dial for the sliding/tilting
roof
» Fig. 24.
C
.
D
and hold it in this position (spring-tensioned po-
B
.
A
towards the roof.
E
» Fig. 24.
A
down and then pull it forwards.
E
Unlocking and locking


41