Skoda Yeti Owner's Manual page 66

64 Seats and Stowage
Storing setting
Storing seat and exterior mirror settings for driving forward
Switch on the ignition.
–
Adjust the seat ⇒ p age 63.
–
Adjust both exterior mirrors ⇒ p age 58.
–
⇒ f ig.
– Press button SET A 46.
Press one of the memory buttons
–
ton SET - an acknowledgement signal confirms that the seat setting is stored..
Storing exterior mirror setting for reversing
– Switch on the ignition.
Turn the exterior mirror control to position  ⇒ p age 58.
–
Engage reverse gear.
–
Move the right exterior mirror into the desired position ⇒ p age 58.
–
Take the vehicle out of gear. The set position of the exterior mirror is stored.
–
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the
⇒ f ig.
three memory buttons B 46, that is three in total. After pressing the corre-
sponding memory button , the seat and the exterior mirror are automatically
B
moved into the positions which have been allocated to this button ⇒ p age 64.
Fig. 46 Driver seat: Memory buttons
and SET button
within 10 seconds after pressing the but-
B
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of
the driver seat.
Note
● For safety reasons, it is not possible to store this position if the inclination an-
gle of the seat backrest is more than 102° in relation to the seat cushion.
● When storing settings with the memory buttons, we recommend that you be-
gin with the front button and assign a memory button to each additional driver.
● Each new setting stored with the same button erases the previous setting.
● Each time you store the seat and exterior mirror settings for driving forward
you also have to re-store the individual setting of the exterior mirror on the pas-
senger side for reversing.
Assigning the remote control key to the memory buttons
After storing the settings of the seat and exterior mirrors, you have 10 seconds in
order to assign the remote control to the appropriate memory button.
– Withdraw the ignition key.
Press the unlock button ⇒ p age 37, after the successful assignment an audible
–
signal will sound. The setting is stored with the memory button which you
have selected.
If you wish to be able to retrieve the settings which are stored in the memory by
also using the remote control, you have to assign the remote control to a memory
button in each case.
If you wish, you can obtain an additional remote control key from an authorised
ŠKODA Service partner and then assign the remote control key to another memo-
ry button.
Note
● If the remote control had previously been assigned to another memory button,
this setting is then erased by the new assignment.
● If you assign the remote control to a memory button which has already been
assigned to a remote control, the old assignment is also replaced by a new assign-
ment in this case.

£