Close The Washer Door And Press The Start/Stop Button; Once The Program Has Finished - Asko W6884 Eco Operating Instructions Manual

Washing machine
Table of Contents

Advertisement

Washing
7
Close the washer door and
press the Start/Stop button
Note!
A few seconds after you start a program the
washing machine will begin to fill with water from
both the hot and the cold supplies. If for some
reason no hot water is available, the machine
waits for one minute and then fills with cold water
only. The wash drum does not start to rotate
until it begins to fill with water.
Time remaining
The time remaining is shown in hours and
minutes. Once a program is selected, the
estimated program time is displayed. This may
differ from time to time depending on the
temperature of the water entering the machine
and the size of the load. If the program time is
longer than the previous wash with the same
program, '0:01' will be displayed until the program
finishes. This is normal! The next time you use
the program under similar conditions, the
estimated program time will be more accurate.
To add or remove washing after the
program starts
If you want to add or remove items after the
program has started, you can stop the program
by pressing and holding the Door opening button
(key symbol) for three seconds. When you restart
the machine, add any extra detergent needed and
close the washer door. The machine continues
automatically from the point where the program
was interrupted.
Stopping or changing a program
You can stop a program by pressing the
Start/Stop button for three seconds. "Stop"
appears in the display. To restart the machine,
select a new program, add any extra detergent
needed and press the Start/Stop button.
Note!
Do not open the detergent compartment while
the machine is running.
8

Once the program has finished

Once a program has finished, "End"
appears on the display.
The washer door opens automatically once the
program has finished. If you want to deactivate
the automatic door opening function, see the
"Selecting settings" section.
• Remove the load.
• Turn off the main power switch, this will
save energy.
If you have small children or pets at home, close
the washer door once you have removed the
laundry.
Backlighting
Two minutes after the wash program finishes the
display backlighting enters energy saving mode.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents