Table of Contents
Advertisement
Operating instructions
6
Close the washer door and
press the Start/Stop button
Time remaining
"Program Started" is shown on the display.
When the program starts, an estimated program
time, in hours and minutes, is displayed. The
remaining time is updated three times during the
program, based on the actual load and the
incoming water temperature. The first update
takes place after about 15 minutes. The remaining
time is last updated just before the final rinse.
To add or remove laundry after the
program starts
If you want to add or remove items after the
program has started, you can stop the program
by pressing and holding the Door Opening button
(key symbol) for three seconds. When you restart
the machine, add any extra detergent needed and
close the washer door. The machine continues
automatically from the point where the program
was interrupted.
Stopping or changing a program
You can stop a program by pressing the
Start/Stop button for three seconds. "Stop"
appears on the display. To restart the machine,
select a new program, add any extra detergent
needed, and press the Start/Stop button.
NOTE!
Do not open the detergent compartment while
the machine is running.
7
Once the program has finished
Once a program has finished, "End"
appears on the display.
The washer door opens automatically once the
program has finished. If you want to deactivate
the Automatic Door Opening function, see the
"Selecting settings" section.
• Remove the laundry.
• Turn off the main power switch as this will save
energy.
If you have small children or pets at home, close
the washer door once you have removed the
laundry.
Backlighting
Two minutes after the wash program finishes the
display backlighting enters energy saving mode.
Customer Care Center
1-800-898-1879
www.askousa.com
19
Advertisement
Table of Contents
