Table of Contents
Advertisement
FEATURES & OPERATING CONTROLS
MOUNT INTO
THREADED
HOLES IN
WARMER
FRAME
TURN BOTTOM
PORTION TO
ADJUST
A. INFINITE SWITCH
1. On INFINITE SWITCH CONTROLLED warmers, power is
applied to the heating element based on the control knob
position and the amount of energy consumed.
2. The desired temperature is controlled by rotating the
TEMPERATURE CONTROL KNOB. The knob may have a
numeric scale, where higher numbers correspond to higher
temperature. LO is the lowest temperature setting; PREHEAT
is a "continuous on" setting. Infinite switch controlled warmers
are equipped with a hi-limit device to prevent overheating. The
hi-limit will self-reset after the warmer has cooled.
3. On warmers equipped with an INDICATOR LIGHT, the light will
glow when the infinite switch is in any position other than OFF.
4. The TEMPERATURE CONTROL KNOB will rotate without
stopping, with PREHEAT and OFF having obvious detents.
The OFF position is a "positive" OFF (i.e. the switch is positively
held in the open position).
NOTE: Since the infinite switch is basically a timing device, no
temperature sensing component is required.
B. ADJUSTABLE LEGS
1. Countertop warmers may be equipped with adjustable legs.
These legs allow for:
a. leveling the warmer
b. ventilation around the warmer, and
c. cleaning under the warmer.
2. Adjustable legs are supplied with the warmer, these legs
MUST be properly installed before the warmer is placed into
operation. See page 11 for alternate legs.
2
Advertisement
Table of Contents
