Updating The Disklavier - Yamaha Disklavier E3 Operation Manual

4
Select a desired option with the cursor buttons ([
then press [ENTER].
The selected option is executed.
5
Press [STOP] to complete the operation.

Updating the Disklavier

Shut down the Disklavier [PLAY/PAUSE] and [ON/OFF]
You can update the Disklavier firmware using update program (saved on
the CD-ROM or USB flash memory, or downloaded via Internet).
You can download the update program from the following website:
http://download.yamaha.com/
1
Make sure that Disklavier is shut down.
2
Holding [PLAY/PAUSE] on the control unit, press [ON/OFF].
+
Hold
The current version information of each module appears one after
the other.
3
Make sure that the update program is prepared, then press
[ENTER] on the control unit.
The starting screen appears.
4
Press [ENTER] on the control unit again.
After a while, the update confirmation message of each module
appears.
CTRL system v2.20
*UPDATE
EW ITE SYSTEM P OG AM
(ENT)
v2.20  v3.00
MC -SURE? (PLAY,STOP)
Note:
] [ ]),
Do not execute these options with
no instructions from the service
personnel.
Note:
For this operation you have to insert
the CD-ROM or USB flash memory
in which the update program is
saved or download update program
via Internet, and shut down the
Disklavier.
Note:
Depending on the version or
specification of the Disklavier, the
actual indications for the version
and module names may differ from
ones depicted here.
(ENT)
Chapter
11
Other Settings
121