Advertisement
Updating the Firmware
Notice: The following must be observed during the firmware update
Do not turn off the instrument during the update.
Do not remove the USB flash drive from the instrument.
When you run into a trouble during the firmware update, refer to the
section located at the end of this document.
1. Make sure that the instrument is turned off before updating the firmware.
2. Insert the USB flash drive with the copied firmware into the USB [TO DEVICE] terminal.
3. Press and hold the [▶/ll] (PLAY/PAUSE) button, and turn on the instrument.
Keep the [▶/ll] button held down until the display shows the following message.
The red marking below shows where the [▶/ll] button is located on the panel.
4. Press the [▶/ll] button again when the display shows the following message.
Troubleshooting
Advertisement
