Setting The Passcode To Prevent Unauthorized Access - Yamaha Disklavier E3 Operation Manual

Chapter
11
Other Settings
■ Using the Shortcut
Holding the green button on the remote control, press the corresponding
number button on the number keypad to execute the assigned function.

Setting the Passcode to Prevent Unauthorized Access

[SETUP] "Passcode"
You can enter the 4-digit passcode to prevent unauthorized access from
the commercially available external remote controller, or you can also set
the MAC address of the external remote controller to allow it to access
your Disklavier without entering the passcode.
■ Setting the Passcode
1
Press [SETUP] on the remote control.
The setup menu screen appears.
2
Select "Passcode" with the cursor buttons ([
[ ]), then press [ENTER].
The passcode setting screen appears.
3
Press [
114
+
=SETUP MENU=
*TimerPlay *AudioI/O
*MIDI *M-Tune
=SETUP MENU=
*Passcode *Reset
=Passcode=
>Passcode=####
] and [ ] to move the cursor left and right.
(1/3)]
] [ ] [
_(3/3)
]-+
Note:
These settings are not required for
the use of the remote control of this
unit. In case of using an external
remote controller, refer to the user's
guide for that remote controller.
Note:
If changes are inappropriately made
for these settings, the external
remote controller may not function
properly. In such cases, enter
"####" to reset the passcode setting.
]