Setting Up; Power Requirements - Yamaha PSR-E283 Reference Manual

Setting Up

Power Requirements

Although this instrument can draw power either from an AC
adaptor or batteries, Yamaha recommends the use of an AC
adaptor whenever possible.
Using an AC Adaptor
Connect the AC adaptor in the order shown in the
illustration.
DC IN jack
(page 9)
1
AC adaptor
WARNING
• Use only the supplied or specified AC adaptor (page 48).
Using a different power adaptor may cause a malfunction,
overheating, fire, etc. Note that in such cases, Yamaha
may not be able to guarantee the product even within the
warranty period.
• When using an AC adaptor with a removable plug, make
sure to keep the plug attached to the AC adaptor during use
and storage. Inserting just the plug into an outlet can cause
electric shock or fire.
• Never touch the inner metallic section of the plug to avoid
electric shock, short circuit, or damage. If the plug comes
off, push it in until it securely clicks in place. Also be careful
that there is no dust or other foreign matter between the AC
adaptor and plug.
For PA-130
• When setting up the instrument, make sure that the AC outlet
you are using is easily accessible. If trouble or a malfunction
occurs, immediately press the [
(page 6) to turn the power off and disconnect the plug
from the outlet.
• When disconnecting the AC adaptor, turn off the power of the
instrument and follow the order shown above in reverse.
2
To AC outlet
Plug
• Place the plug against the far
side, and then firmly push it
in until it clicks.
• The shape of the plug differs
depending on your area.
] (Standby/On) switch
Using Batteries
This instrument can use AA size alkaline, manganese
dry cell, or rechargeable nickel metal hydride batteries
(rechargeable batteries). However, the use of alkaline or
rechargeable batteries is recommended, as the instrument
may consume large amounts of power depending on use.
WARNING
• When the batteries run out, or if the instrument is not to
be used for a long time, remove the batteries from the
instrument.
1
Make sure that the power of the instrument is off.
2
Turn the instrument over on a soft cloth or cushion
and open the battery compartment cover located on
the bottom panel.
3
Insert the six new batteries, being careful to
follow the polarity markings on the inside of the
compartment.
4
Replace the compartment cover, making sure that it
locks firmly in place.
Make sure your instrument settings are configured correctly
according to the type of battery you are using (page 6).
PSR-E283 YPT-280 Reference Manual
5