Setting Remotely Controlled Parameters - Harris DA-DHR6802+ Installation And Operation Manual

Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 3: Operation

Setting Remotely Controlled Parameters

Table 3-2. DA-DH6802+, DA-DS6802+, DA-H6802+ Remotely Controlled Parameters
Name
Backup mode
Output configuration
Signal present [RO]
Slew rate*
Loss of input alarm
Loss of lock alarm
* DA-DH6802+ only
24
Table 3-2 and Table 3-3 on page 25
accessible remotely. See your CCS control software application manual
or online help for more information on setting and monitoring these
parameters remotely.
Legend
Bold option=Indicates that this is the default setting for the parameter.
[RO]=Indicates that parameters are read-only/feedback, and cannot be
used to select controls.
All parameters clip unless otherwise noted.
Range
• 0 = Disable
• 1 = Enable
• 0=1×4
• 1=1×8 ch. 1
• 2=1×8 ch. 2
• 0=No
• 1=Yes
• 0=HD
• 1=SD
• 2=Auto
• 0=Disable
• 1=Enable
• 0=Disable
• 1=Enable
DA-DHR/DH/DSR/DS/HR/H6802+ Installation and Operation Manual
describe parameters that are
Description
Loss of signal (input 1) switching enable,
automatically switch both output MUXs to select
input 2 when input 1 has lost its input signal
Allows you to select if the card is in dual 1×4 or 1×8,
with input 1 routed to all outputs; or 1×8 with input 2
routed to all outputs
Indicates if the input is present or not
Allows you to specify the slew rate as either HD
(1.485 Gb/s or 3.0 Gb/s) or SD
Enables or disables the Loss of Input alarm
Enables or disables the Loss of Lock alarm