Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Setting J3 Jumpers
Note
You need to configure modules
for local or remote operation
before power-up. To change the
configuration, first remove
power from the module, reset
the jumper, and then reapply
power.
DA-DHR/DH/DSR/DS/HR/H6802+ Installation and Operation Manual
The J3 jumper is used to set channel configuration, control mode, and
enabling input backup. Follow this procedure to set the jumper:
1. Locate jumper set J3 on the module.
location of the jumper set.
Figure 2-2. J3 Jumper Set Location
2. Place a jumper on the pin that corresponds to the setting that you
want. (See
page 21
Figure 2-2
for a description of the J3 settings.)
Chapter 2: Installation
shows the standard
15