Setting J4/J5 Jumpers - Harris DA-DHR6802+ Installation And Operation Manual

Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 2: Installation

Setting J4/J5 Jumpers

16
The J4 and J5 jumpers are used to set the output slew rate control.
Follow this procedure to set the jumpers:
1. Locate the J3 and J4 jumper sets on the module.
the standard location of the jumper sets.
Figure 2-3. J4/J5 Jumper Set Locations
DA-DHR/DH/DSR/DS/HR/H6802+ Installation and Operation Manual
Figure 2-3 shows