Bank Mode - Eventide TimeFactor User Manual

TimeFactor User Guide
Note: Tapping with Tempo OFF sets both Delays (A and B) to the same value.

Bank Mode

In Bank Mode, the Billboard displays the Bank and Preset Number of the currently running
Preset. The Left and Middle Footswitches are used to instantly select or Bypass either Preset 1
or Preset 2. Presets are stored in pairs and each pair of Presets is called a Bank. There are a
maximum of 50 Banks - a total of 100 Presets.
The Billboard displays the current Bank and Preset number. Banks are numbered from 1 to 50
and Presets are numbered 1 and 2.
Note: The 100 Presets can be based on any of the Effects. You can choose to have all 100
presets based on DigitalDelay, or any combination of the nine Delay effects.
Loading Presets
The Preset numbers correspond to the Left and Middle Footswitches.
To Bypass the Preset, simply press the Footswitch corresponding to the loaded Preset. Press
again and the Preset becomes active.
The following attributes are saved with Presets and recalled when Presets are loaded:
1) Parameter knob values.
2) Mix value.*
3) Tempo/Tap value.*
4) Tempo On/Off status.
5) Expression pedal mapping.
* Note: TimeFactor can be set up to change the Mix and/or Tempo values when a Preset is
loaded or to ignore the values saved with the Preset. While Mix and Tempo values are always
saved with the Preset, you may prefer to have your current Mix and/or Tempo stay the same
as you switch from Preset to Preset. Turn MIX or TEMPO ON in the Global menu to do that.
With MIX or TEMPO ON, the values saved with the Preset are ignored and the current values
are used. Global is described later in this User Guide.
35
The Footswitches