Eventide TimeFactor Quick Start Manual

Hide thumbs Also See for TimeFactor:

Procedure:

1. Take the power supply and plug it into the wall first, plug the other end of the

power supply into the TimeFactor.

3. While the unit powers up, quickly push and hold down the encoder knob, the

left most knob in the lower row of knob controls and middle footswitch, labeled

"Repeat". As soon as you see "INITIALIZING..." on the display, let go of the encoder

knob and middle footswitch. The unit will initialize the unit and then boot up as normal.

5. The unit is now initialized and the preset banks are unlocked.

To check if the unit is properly initialized:

1. Unplug the power supply from the unit to power it off.

2. Plug the power supply back into the unit to power it on.

3. Once the unit has been completely booted up, push and hold down the encoder

button and right footswitch, labeled "Tap".

TimeFactor Initialization

Table of Contents

Do you have a question about the TimeFactor and is the answer not in the manual?

Page 1 Procedure: 1. Take the power supply and plug it into the wall first, plug the other end of the power supply into the TimeFactor. 3. While the unit powers up, quickly push and hold down the encoder knob, the left most knob in the lower row of knob controls and middle footswitch, labeled “Repeat”.
Page 2 4. If done correctly, the display will read “BYPASS”. The LEDs above the left and right footswitch will blink red. 5. Turn the encoder knob to the right until the display reads “UTILITY”. 6. Push the encoder knob down. The display will read “CATCHUP”. 7.